VAL Avionics NAV 2000 Guia de Instalação descarregar pdf (Página 217)

Autopilot Servo Installation, Configuration, and Calibration

SkyView System Installation Guide - Revision R 10-23

If the autopilot is engaged when this condition is detected, it will remain engaged.

Set to YES if the optional 5 kΩ resistor is installed across the 2 terminals of the Disengage/CWS

Button. Set to NO if the resistor is not installed. Default is NO.

To set the broken line detection mode:

1. Go to the Enable Broken Line Detect Adjust Page (SETUP MENU > AUTOPILOT SETUP >

DISENGAGE BUTTON > ENABLE BROKEN LINE DETECT).

2. Set to YES or NO.

3. Press ACCEPT to save or press CANCEL to return to the Disengage Button Menu.

Control Wheel Steering Mode

Control Wheel Steering may be set to YES or NO. Setting HOLD TO ENGAGE to YES allows you to

take temporary manually control of the aircraft to redirect its targets while pressing and

holding the Disengage/CWS Button when the autopilot is engaged. See the SkyView Pilot’s User

Guide for details on Control Wheel Steering behavior. To set the control wheel steering mode:

1. Go to the Control Wheel Steering Mode Adjust Page (SETUP MENU > AUTOPILOT SETUP

> DISENGAGE BUTTON > CONTROL WHEEL STEERING MODE).

2. Set to YES or NO.

3. Press ACCEPT to save or press CANCEL to return to the Disengage Button Menu.

Autopilot In-Flight Tuning Procedures

This completes the on-ground portion of Autopilot setup.

Next, please use the SkyView Autopilot In-Flight Tuning Guide to maximize the dynamic flying

performance of the Autopilot as installed in your aircraft.

The latest version of the SkyView Autopilot In-Flight Turning Guide can be downloaded from

http://docs.dynonavionics.com.

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 400 401

Sem comentários

VAL Avionics NAV 2000 Guia de Instalação Página 217