VAL Avionics NAV 2000 Guia de Instalação descarregar pdf (Página 262)

100

101

SV-ADSB-470 Installation, Configuration, and Testing

14-4 SkyView System Installation Guide - Revision R

sources of these products. You may also find it helpful to own a pin insertion/extraction tool as

well.

Additional harness construction and wiring information can be found in Appendix C: Wiring and

Electrical Connections.

The SV-ADSB-470 has a single D9 female connector which provides the data and power inputs

to the module. A single BNC connector attaches to the antenna.

SV-ADSB-470 Interface – Pinout (Female D9 on module / Male D9 on harness)

Function

Notes

10-30V DC

Connect to Aircraft Power

SV-ADSB-470 Serial RX

Data Input from SkyView

SV-ADSB-470 Serial TX

Data Output to SkyView

Ground

Connect to Aircraft Ground

No Connect

Table 46 - SV-ADSB-470 Female D9 Pinout

The pin out depicted in Figure 91 below depicts the view from the rear of your male D9

connector – the view you will have of your harness connector as you are inserting pins into the

harness. Note that the pin numbers are labelled on the face of both the female and male

connector.

Figure 91 - SV-ADSB-470 connector diagram (from back side of male D9 connector on the wiring harness)

The following table shows the connections for each of SkyView’s nominally available serial ports

(serial port 5 is usually used for connection to the SV-GPS-250 module). Only ONE of the

following serial ports will be used:

1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 400 401

Comentários a estes Manuais

Sem comentários

VAL Avionics NAV 2000 Guia de Instalação Página 262

Comentários a estes Manuais