VAL Avionics NAV 2000 Guia de Instalação descarregar pdf (Página 81)

SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration

SkyView System Installation Guide - Revision R 4-21

Emergency Location Transmitter (ELT)

SkyView can provide a GPS data stream to ELTs that accept GPS data in NMEA format.

 Wire a serial transmit (TX) line from one display to the receive (RX) line on the ELT. If you

have more than one SkyView display, make the same connection to all SkyView displays.

 Ensure there is a shared ground between the SkyView display and the ELT. If you have more

than one SkyView display, make the same connection to all SkyView displays.

 Configure the SkyView display serial port:

SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL PORT x SETUP

SERIAL IN DEVICE: (don’t care, does not affect ELT)

SERIAL IN/OUT BAUD RATE: (set to match speed of ELT; typically 4800 or 9600)

SERIAL OUT DEVICE: NMEA OUT (BASIC)

Dynon ADAHRS / EMS / SYSTEM / NMEA (GPS) Data Outputs

To output real-time data to an external serial device, such as a serial data logger or other device

that accepts NMEA or Dynon formats:

 Wire a serial transmit line from one display to the receive line on the external serial device.

If you have more than one SkyView display, make the same connection to all SkyView

displays.

 Ensure there is a shared ground between the SkyView display and the external serial device.

If you have more than one SkyView display, make the same connection to all SkyView

displays.

 Configure the serial port on the display appropriately under SETUP MENU > SYSTEM SETUP

> SERIAL PORT SETUP, SERIAL PORT x SETUP > selecting the desired output data format.

TIS Format Traffic Output

SkyView can be configured to output TIS format traffic information for external display on other

avionics that can receive traffic in TIS format. When this option is selected, only the actual TIS

traffic from a SV-XPNDR-261/262 is included in this serial data stream. This stream does not

include ADS-B, FLARM, Zaon, or other traffic sources that may be available to SkyView.

 Wire a serial transmit line from one display to the receive line on the external serial device.

If you have more than one SkyView display, make the same connection to all SkyView

displays.

 Ensure there is a shared ground between the SkyView display and the external serial device.

If you have more than one SkyView display, make the same connection to all SkyView

displays.

 Configure the serial port on the display appropriately under SETUP MENU > SYSTEM

SETUP > SERIAL PORT SETUP, SERIAL PORT x SETUP > TIS OUT (330 FORMAT).

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 400 401

Sem comentários

VAL Avionics NAV 2000 Guia de Instalação Página 81