VAL Avionics NAV 2000 Guia de Instalação descarregar pdf (Página 254)

Vertical Power VP-X Integration and Configuration

13-2 SkyView System Installation Guide - Revision R

LOCAL DISPLAY SETUP > DISPLAY HARDWARE INFORMATION). A VP-X License Code can

be purchased for the entire aircraft you wish to enable the VP-X software features on.

This six character License Code is then entered in SETUP MENU > LOCAL DISPLAY SETUP

> LICENSE > LICENSE CODE. If you have more than one display in the aircraft, choose one

to install it onto and provide information for only that display. Once any display is

licensed, all connected displays in the Aircraft can use the Vertical Power software

features.

4. An SV-VPX-290 VP-X Software Certificate may be purchased from Dynon Avionics or any

authorized Dynon Avionics retailer. This certificate can be redeemed for a license code

that can be entered in SETUP MENU > LOCAL DISPLAY SETUP > LICENSE > LICENSE CODE.

To redeem a certificate simply follow the instructions on the certificate itself. Similar to

the above, you will need to redeem your certificate by visiting

http://license.dynonavionics.com with your SkyView display model and serial number

ready. Alternatively, you can call Dynon Avionics directly at 425-402-0433 to redeem a

certificate.

Physical and Electrical Installation

Refer to the Vertical Power installation documentation for instructions on the physical and

electrical installation of the VP-X system.

Up-to-date installation manuals, wiring diagrams, and “how-to” guides for the VP-X system can

be found at http://verticalpower.com/documents/.

SkyView modules such as the SV-ADAHRS-200/201, SV-EMS-220/221, and SV-

ARINC-429 receive power via the SkyView Network. Their power supplies are

managed entirely by the SV-D1000 and SV-D700 displays, and cannot be

separately monitored by the VP-X system. However, SkyView components that

have power supplied by ship’s power, such as the Autopilot servos, SV-ADSB-470,

SV-COM-C25/X83, SV-XPNDR-261/262, and heated AOA/pitot probe can have their

power monitored by the VP-X by routing the power connections for those

components via the VP-X

A Dynon SkyView D37 harnesses for a single display contains a pair of power and

ground wires. These pairs of wires are a SINGLE power input, and must be

connected to a single VP-X input when using the VP-X to provide power to

SkyView displays. The dual wiring scheme is needed to provide adequate power to

the SkyView displays given the electrical constraints of the particular wires and D-

sub connections used. These wires should not be sent to separate power channels

or be considered redundant power sources.

Serial Port Connection

All communication between the VP-X system and SkyView is accomplished via a single

bidirectional serial connection. To accomplish this:

1 2 ... 249 250 251 252 253 254 255 256 257 258 259 ... 400 401

Sem comentários

VAL Avionics NAV 2000 Guia de Instalação Página 254