VAL Avionics NAV 2000 Guia de Instalação descarregar pdf (Página 236)

SV-XPNDR-261/262 Installation, Configuration, and Testing

11-18 SkyView System Installation Guide - Revision R

o SKYVIEW: SkyView reports its GPS position to the transponder via its nominal

SkyView<>SV-XPNDR-261/262 serial connection. Using this setting causes the

transponder to transmit the following ADS-B performance parameters:

 SIL: 0 (Unknown integrity)

NACp: 8, 9 or 10. Dynamic, as reported by GPS.

NIC: 8 (Containment radius <0.1 NM)

NACv: 1 (10m/s accuracy)

 GPS STATUS: Displays whether the SV-XPNDR-261/262 is receiving valid GPS data.

 ADS-B IN FREQUENCY: Tells the ADS-B system which frequency (US-only) the aircraft can

receive traffic/weather information on.

If an SV-ADSB-470 is installed and configured under SETUP MENU > SYSTEM SETUP

> SERIAL PORT SETUP, this option will be unavailable: The SV-ADSB-470

automatically receives ADS-B In traffic and weather via the UAT frequency band.

Note that the options in the ADS-B IN FREQUENCY only have an effect with

transponder software 2.02 or above. See the Transponder Software Updates

section below for more information about transponder software.

o NONE: The aircraft does not have ADS-B In capability

o 978 MHz UAT: The aircraft can receive ADS-B traffic and/or weather information via

a non-Dynon UAT band (978 MHz) device.

o 1090 MHz ES: The aircraft can receive ADS-B traffic information via a 1090 MHz ES

(extended squitter) device.

Altitude Encoder Calibration

In most transponder systems, a calibration is normally carried out every 24 months, as part of

the altimeter checks on the aircraft. The maximum allowed difference between the primary

altimeter and the altitude encoder is 125 feet in ETSO C88a and TSO C88b. The primary

altimeter in SkyView and the altitude encoder are one and the same device. It is therefore

impossible for the encoder and the primary altimeter to exceed 125 feet of altitude difference.

They will always be exactly the same as each other, thereby meeting the TSO requirements.

Therefore, no altitude encoder calibration is possible or necessary.

At times it may be useful to know the altitude that is being reported to the transponder. Since

SkyView sends pressure altitude to the SV-XPNDR-261/262, setting BARO to 29.92 will display

the pressure altitude being transmitted to the transponder in the normal SkyView altitude

display on the right side of the PFD page.

However, note that there is a single point altitude adjustment, located in SETUP MENU >

HARDWARE CALIBRATION > ADAHRS CALIBRATION > ALTITUDE ADJUST that adjusts SkyView’s

barometric altimeter. This adjustment affects both the displayed altitude and the encoded

altitude that is sent to other devices.

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 400 401

Sem comentários

VAL Avionics NAV 2000 Guia de Instalação Página 236